boeing247 wrote on Dec 15
th, 2012 at 7:10pm:
Thanks for the new values, Mark! Are there any other variables that should be adjusted? (e.g. drag variables)
And as a side note, the door coordinates seem to be off. Does anybody have fixed coordinates so the jetways properly lines up with the door? The jetways seem to want to line up right between the front entrance and the wing for me.
There is one other value that I changed in the
[TurbineEngineData] settings. I'm not sure if it makes a difference though.
[TurbineEngineData]
fuel_flow_gain = 0.002 //Gain on fuel flow
inlet_area = 9.6 //Square Feet, engine nacelle inlet area
//19.6rated_N2_rpm = 29920 //RPM, second stage compressor rated value
static_thrust = 17400 //25000afterburner_available = 0 //Afterburner available?
reverser_available = 1 //Thrust reverser available?
ThrustSpecificFuelConsumption = 0.385 //Thrust specific fuel consumption (Jets)
AfterBurnThrustSpecificFuelConsumption = 0 //TSFC with afterburn/reheat engaged
I remember someone else saying something about the
inlet_area being only about
9.6 square feet, so I changed that too. I'm not sure if it makes much difference because I never tested it. I might give it a try so I can see if it does.
@CoolP. I try t keep it relatively close to the original (so I can change them back to help someone if necessary), so I don't install MODS (except for the V-One MOD).