(UTC)
  Visit Captain Sim web site  
  Welcome, Guest. Please Login or Register

  

‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
flaps indicator (Read 571 times)
NaMcO
Full Member
*
Offline



Posts: 77
Joined: Feb 25th, 2014
flaps indicator
May 10th, 2020 at 1:17pm
Print Post  
When pressing on flaps control to increase flaps position from 0, flaps speed in the indicator is normal, takes a few seconds to go from 0 to 1.

If, during this time, you use the flaps increment controls once again, the indicator jumps really quickly to 1 and then to 5 not respecting any timings. I couldn't see this behaviour from 5 to 15, to 20 etc, only from 0 to 1 then 5 if you act on the controls quickly.
  
Back to top
 
IP Logged
 
Captain Sim
CS Team
*
Offline



Posts: 4245
Joined: Nov 7th, 2005
Re: flaps indicator
Reply #1 - May 12th, 2020 at 4:22pm
Print Post  
Quote:
If, during this time, you use the flaps increment controls once again, the indicator jumps really quickly to 1.

Right, because you forced the indicator to skip the SLATS extension indication and start indication of the FLAPS extension, which has a priority.

From the Manual:
1. Flap Lever
UP - the slats and flaps are retracted.
1 – the slats extend to the midrange position the flaps remain retracted
5, 15, and 20 -
the slats remain in the midrange position
the flaps extend to the commanded position

3. Flap Position Indicator
- Between UP and 1 - the slats are between the retracted and midrange
position.
- 1 to 30 – the flaps are in the indicated position
  


Customer Support
Back to top
WWWFacebookYouTube  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board  ^Top   

CAPTAIN SIM FORUM » Powered by YaBB 2.6.0!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge