Visit Captain Sim web site  
  Welcome, Guest. Please Login or Register

 

Page Index Toggle Pages: 1 Send TopicPrint
C-130 T.I.T. Gauge with T.I.T. Follow (Read 2393 times)
fsxpaul
Full Member
*
Offline



Posts: 165
Joined: Mar 11th, 2013
C-130 T.I.T. Gauge with T.I.T. Follow
Aug 21st, 2016 at 8:36pm
Print Post  
This is an XML gauge that simulates the Turbine Inlet Temperature (T.I.T.) for Captain Sim's C-130 X-perience version 1.3 for FSX.
Note: All gauge click functions are accessed from the 2D gauge only.

Available in the Avsim library. Search for: cs_c130_tit_gauge_ver1.0.zip

Below are features included in this gauge:
- Simulated Turbine Inlet Temperature (T.I.T.)
- Virtual Cockpit installation
- Access to 2D panel via VC click-spot (Radio Stack)
- T.I.T. follow for Take-off, climb and cruise
- Display toggle (top): T.I.T., Cruise Ceiling and Current Elevator Trim
- Display toggle (bottom): Engine Torque, Engine Fuel Flow and True Airspeed (knots)
- T.I.T. follow will disconnect when altitude hold is selected and climb temperature is above 900°C
- Pre-defined selectable temperatures for T.I.T. follow: user selectable, 970°, 1010° and 1049°
- T.I.T. display will indicate T.I.T. follow is within ±2°C control during climb
- GTC sound fix for start-up, run and shut-down of Gas Turbine Compressor



  
Back to top
 
IP Logged
 
David Paul
Senior Member
*
Offline



Posts: 270
Joined: Dec 25th, 2010
Gender: Male
Re: C-130 T.I.T. Gauge with T.I.T. Follow
Reply #1 - Feb 5th, 2017 at 10:22am
Print Post  
Paul, thanks for taking the time to create this gauge!   I think I have it installed correctly, but I'm still trying to figure out how to use it for takeoff and climb.
  


I5-6600K @4.2 GHZ | GTX-1070 | 32GB RAM | Windows 7/10 Dual Boot on SSD and M.2
FSX-Acceleration | P3D 4.5 | MSFS 2020
Back to top
 
IP Logged
 
fsxpaul
Full Member
*
Offline



Posts: 165
Joined: Mar 11th, 2013
Re: C-130 T.I.T. Gauge with T.I.T. Follow
Reply #2 - Feb 5th, 2017 at 3:15pm
Print Post  
David Paul wrote on Feb 5th, 2017 at 10:22am:
Paul, thanks for taking the time to create this gauge!   I think I have it installed correctly, but I'm still trying to figure out how to use it for takeoff and climb.


Did you read the instructions? If the're not clear enough please let me know  Wink

I'll be happy to explain more if needed.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
 
  « Board Index ‹ Board  ^Top