Hi quick question is the p3d version a native installer as I own fsx version using migration tool and running in legacy mode - would I get a better performing 777 if I have the p3d version - what is the differences

Regards, Rich

Hi Buddy:

Hope all is well - better in what way will it perform better ? asI am only getting 15fps in and around airports with all setting at normal - no shadows on and I have a high end system other than that seems very nice - thank you

Thanks Brother - about the same her as my autogen was at normal on 3 sliders - and I am getting close to 30 outside airports - maybe this will get better with p3d next update - looking good for the future

Pardon my ignorance, but I can't seem to start my own thread so I'm sort of hijacking this one...

I just purchased the P3D version (also own the FSX version). After installing I seem to run into the anti-piracy measures. Following the suggestions in the knowledgebase does not work (reinstalling, removing registry keys, etc etc.).

Has anyone else had this issue, or does someone have some more suggestions to try before I turn to CS support?

For good measure:

W8.1 Update 1
Tried reinstalling
Tried reinstalling after removing registry values and rebooting
All installs as Administrator
P3D V2 outside C:\
Any anti-virus ignores the P3D folder/drive and also the folder/drive where the installer is located.

I hope this is fixable, I hear good things about 1.4.

Do I need 10 posts before I can start a thread?

Cheers, Rob.

Did you install the P3D version of the 777 - also the yoke all the way to the left means you have to turn on all the switches behind the captains chair its above the cabin door - bit hard to get at but you will see them there - not on the overhead panel - also if you load another basic aircraft engines running - just load 777 after and you will not have to worry about those switches they will be on - I think they are hydraulic switches

Did you turn off/disabled your Anti-Virus software while you were installing the 777? It could be that your AV saw a/some gauge(s) as threats, and prevented them being installed.

Take a look at the image in this post: http://captainsim.org/yabb2/YaBB.pl?num=1403249614/27#27, and check that your CS_B777-200ER_GE\panel has all the gauges in it.

You should try manual offline activation.

Very strange indeed.

At least you got it installed in the end.

Markoz,

I just got Prepar3D V2 mostly using and testing VFR flights. So far only have all my Carenado's fleet. Now, how is the B777 handles on this one?
I can get away with clouds on the ground and the ocean, But i like the shadows inside the VC. Now how is the frame on that, especially like on a FSDT scenery airports?


Thanks,
Kin M.
(Klax)

Thanks....

The last few days i've been tweaking it, so i can balance the quality and the performance. I will try to fly with it more and experiment before i can dive on the CS777 version. So far, looking good...i have REX, OPUS and FTX Global on it now.


Kin M.
(Klax)