Visit Captain Sim web site  
  Welcome, Guest. Please Login or Register

 

Page Index Toggle Pages: 1 ... 4 5 [6]  Send TopicPrint
 25 SYSTEMS & DYNAMICS (Read 8368 times)
PeteFly82
Full Member
*
Offline



Posts: 86
Location: Switzerland
Joined: Jan 22nd, 2016
Gender: Male
Re: SYSTEMS & DYNAMICS
Reply #75 - Feb 24th, 2021 at 10:24am
Print Post  
APU was already running and 757 was also linked to external power.
Now I switched OFF the external power link and electricity automatically switched to APU power. So far so good.

But during that automatic electricity switch, the right FMS in VC lost all text on it.
The text on the right FMS in VC did only re-appear after showing/closing the right FMS as 2D gauge.
  
Back to top
WWW  
IP Logged
 
Angel of Attack
Full Member
*
Offline



Posts: 117
Joined: Dec 15th, 2019
Re: SYSTEMS & DYNAMICS
Reply #76 - Feb 26th, 2021 at 1:44am
Print Post  
CDU2 goes blank scenen after power switch on R AC BUS.
This only happens when CDU2 are not on the IDENT (the default page on first power up), normally I set it on LEGS page in preflight, after pushback and start ENG2, as the power switch to APU to ENG2, FO's screen flashes as the power switch, but the CDU2 would not come up again, untile I press any buttons on it.

Might related to pete's problem above, but a little different. not very annoying, but hope it'd be easy to fix.
  
Back to top
 
IP Logged
 
PeteFly82
Full Member
*
Offline



Posts: 86
Location: Switzerland
Joined: Jan 22nd, 2016
Gender: Male
Re: SYSTEMS & DYNAMICS
Reply #77 - Mar 20th, 2021 at 8:57pm
Print Post  
2D gauge of the VC navigation display only updating every 30-60sec
happens often to left one 2D gauge, sometimes even to the right one 2D gauge
  
Back to top
WWW  
IP Logged
 
Angel of Attack
Full Member
*
Offline



Posts: 117
Joined: Dec 15th, 2019
Re: SYSTEMS & DYNAMICS
Reply #78 - Mar 21st, 2021 at 3:26am
Print Post  
PeteFly82 wrote on Mar 20th, 2021 at 8:57pm:
2D gauge of the VC navigation display only updating every 30-60sec
happens often to left one 2D gauge, sometimes even to the right one 2D gauge

I have noticed that only when the gauge quality are set from low to medium, still a bug worth CS to look into.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 ... 4 5 [6] 
Send TopicPrint
 
  « Board Index ‹ Board  ^Top