(UTC)
  Visit Captain Sim web site  
  Welcome, Guest. Please Login or Register

  

  CAPTAIN SIM FORUM › 757 Captain III › 757 Captain III - General › "on APU" panel state issues
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
"on APU" panel state issues (Read 1276 times)
Rupert
New Member
Offline



Posts: 4
Joined: Dec 8th, 2010
"on APU" panel state issues
Dec 27th, 2018 at 7:39am
Print Post  
Hello,

in P3DV4.3 after a change of panel state from ready for take off to "on APU" the clickspots in the VC center pedestal are not clickable, in the 2D panel they work.

Any suggestions?

thx
  
Back to top
 
IP Logged
 
FraPre
Full Member
*
Offline



Posts: 51
Location: Germany
Joined: Sep 6th, 2015
Gender: Male
Re: Version 1.3 is available
Reply #1 - Dec 27th, 2018 at 10:52am
Print Post  
Hi,

can it be that with version 1.3 (FSX) at least the starting state "ON APU" is no longer correctly built up? For me, many switches are on, which should be off, but the switch for the APU, which is running, is OFF. I then completely uninstalled the whole time completely and reinstalled version 1.3, but no succes.
  
Back to top
 
IP Logged
 
Captain Sim
CS Team
*
Offline



Posts: 4215
Joined: Nov 7th, 2005
Re: Version 1.3 is available
Reply #2 - Dec 27th, 2018 at 3:23pm
Print Post  
FraPre wrote on Dec 27th, 2018 at 10:52am:
Hi,

can it be that with version 1.3 (FSX) at least the starting state "ON APU" is no longer correctly built up? For me, many switches are on, which should be off, but the switch for the APU, which is running, is OFF. I then completely uninstalled the whole time completely and reinstalled version 1.3, but no succes.


No need to reinstall. You can just re-save the flight with any corrections.
Moreover custom panel state setup is available via FMC.   
  


Customer Support
Back to top
WWWFacebookYouTube  
IP Logged
 
FraPre
Full Member
*
Offline



Posts: 51
Location: Germany
Joined: Sep 6th, 2015
Gender: Male
Re: Version 1.3 is available
Reply #3 - Dec 27th, 2018 at 3:29pm
Print Post  
I had done that first too, but unfortunately I found the wrong startup status "ON APU". Then I completely reinstalled everything. The wrong condition of many switches in this starting situation remained unfortunately. In version 1.2 there were no problems.
  
Back to top
 
IP Logged
 
Captain Sim
CS Team
*
Offline



Posts: 4215
Joined: Nov 7th, 2005
Re: "on APU" panel state issues
Reply #4 - Dec 27th, 2018 at 3:33pm
Print Post  
Thanks, we'll check the "on APU" panel state.
  


Customer Support
Back to top
WWWFacebookYouTube  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board  ^Top   

CAPTAIN SIM FORUM » Powered by YaBB 2.6.0!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge