Visit Captain Sim web site  
  Welcome, Guest. Please Login or Register

 

Page Index Toggle Pages: 1 Send TopicPrint
Displaying ILS/VOR 2 bearing (Read 1426 times)
liazkam
New Member
Offline



Posts: 2
Joined: Mar 17th, 2010
Displaying ILS/VOR 2 bearing
May 30th, 2010 at 12:37pm
Print Post  
Hi all,

I might hit an old known issue.

I'm tuning into 2 VORs - 1 on NAV1 and one on NAV2. I can hear both correct morse codes.

When the selector is in VOR/ILS 1 the HSI is showing the correct track of NAV1 and the BDH and RMI show track to NAV2.

BUT(!) - when I select VOR/ILS2 I get the same thing. No change at all  - the ADI and HSI show only track to NAV1 and BDH/RMI point to NAV2.

So, how can switch between the two? is there any point in NAV2 beside displaying it on the BDH and RMI.

The manual clearly says that the display on the HSI is selectable by the mode-sel switch: "VOR/ILS 1, VOR/ILS 2 Selection. With the MODE SEL switch in VOR/ILS 1 or VOR/ILS 2 and the FLT DIR switch in NORMAL, the flight director will be in the radio track mode when the corresponding omni receiver is tuned to a VOR frequency."
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
 
  « Board Index ‹ Board  ^Top