Hi All,

Have been looking everywhere for a way to assign buttons to my hardware, finally managed to assign quite a few. It seems that the logic is the same as for the CS 757, so with the SDK for this plus the CS L1011 manual 2 I finally succeeded.

For momentary buttons, like the IAS button, I added the the macro L:KLID=SET to my L1011 macro file in FSUIPC, then I determined the parameter from the two documents mentioned above.

For latching buttons, e.g.  the antiskid, I created separate macros which I set to toggle in the macro file, the name of the buttons were again determined by the mentioned documents.

Best regards Oskar Savo

can you share your macro for the L1011 please ?

From the macro file:

22=L:KLID=SET //(Parameter for momentary button set in the FSUIPC window. for IAS it is 1701005
23=L:O03_001_BUT=Toggle  (Antiskid)
24=L:O15_001_BUT=Toggle  (Cont ignition)
25=L:U06_021_BUT=Toggle   (Pack1 Isolation)

From the L1011 ini file (in profiles) it will look  something like this after assigning in FSUIPC.

24=P0,10,CM9:23,0      -{Macro L1011: L:O03_001_BUT tgl}-
25=P0,11,CM9:24,0      -{Macro L1011: L:O15_001_BUT tgl}-
26=P0,5,CM9:25,0      -{Macro L1011: L:U06_021_BUT tgl}-


Hope this will help.

Br Oskar

Hi guys,

sorry for the bump but has anyone found the LVARs list?
Or have a Profile for the honeycomb yoke and throttle?

thanks

JPFlight

Hi guys,

i've managed to crack the exterior lighting, would anyone be able to give a clue as to which number overhead panel the seatbelt and smoking lights are connected too?

thanks

JPFlight

The Seatbelt and No Smoking buttons are on the O25 panel

---

Hi Markoz,

thanks working like a dream!

JPFlight