CAPTAIN SIM FORUM
767 Captain II (P3D4) >> 767 Captain II - General  >> How to enter a Thrust figure in the FMC?
https://www.captainsim.org/forum/csf.pl?num=1598134153

Message started by sax702 on Aug 22nd, 2020 at 10:09pm

Title: Re: How to enter a Thrust figure in the FMC?
Post by Markoz on Aug 31st, 2020 at 10:46pm
This is with v1.0 in P3Dv4.5

I did noget an INVALID ENTRY when entering 62, or 62C.

Every time I enter a number between 50 and 99, without adding a C to it, it enters fine, and the D-TO is entered as XX oC (i.e. 63 oC D-TO). But...

If I added the F to the number, providing the number was 59 to 99, it is entered with the oF added (i.e. 64F  entered as 64 oF D-TO).
The one strange thing I did notice, was that only the even numbers worked (of those I tried between 66F and 74F). i.e. 66F, 68F, ... 74F.
Entering the odd number, it added 1o to the entry. i.e. 65F would enter as 66oF, etc.
Entering 59F I got 59 oF D-TO.
When I entered 60F, it entered 61 oF, 61F would also enter as 61oF. 62F, and 63F would enter as 63oF.
64F entered as 64oF.
65F, and 66F would enter as 66oF, etc.. I tried this up to 74F.

So all in all, I'm getting the D-TO somewhat okay.

CAPTAIN SIM FORUM » Powered by YaBB 2.6.0!
YaBB Forum Software © 2000-2024. All Rights Reserved.