CAPTAIN SIM FORUM - Print Page

CAPTAIN SIM FORUM
767 Captain II (P3D4) >> 767 Captain II - General >> Speedbrake armed position https://www.captainsim.org/forum/csf.pl?num=1588424045 Message started by Dave763 on May 2^nd, 2020 at 12:54pm

Title: Speedbrake armed position
Post by Dave763 on May 2^nd, 2020 at 12:54pm

Hi all,

Apologies if this has been asked already, just had a quick search.

I am trying to assign the speedbrake lever to a small lever on my hotas warthog throttle quadrant using fsuipc. I have assigned the axis as spoilers, send control to fsuipc, calibrated it and it almost works perfectly apart from the ability to arm them.

As I moved the throttle quadrant lever back, the speedbrake lever moves into the armed area but then it continues past it to full extend.

Does anyone know how I can assign get a joystick lever to select the speedbrake armed position?

Since there is no detent the speedbrake armed key in P3D does not work ( shift + / ).

Thanks

Title: Re: Speedbrake armed position
Post by Louis Vallance on May 24^th, 2020 at 5:24pm

+1 I experience the exact same issue.

Title: Re: Speedbrake armed position
Post by 767pilot on May 26^th, 2020 at 12:45pm

anybody figured this out yet? For all my other planes I also have a button mapped to the shift+/ key for this.

Title: Re: Speedbrake armed position
Post by Angel of Attack on May 27^th, 2020 at 8:20am

It will go to full up when you arm it on the ground, is that the case when you testing?

Title: Re: Speedbrake armed position
Post by 767pilot on May 27^th, 2020 at 3:23pm

my lever doesn't work right for my speedbrake still. It works fine in any other aircraft. anybody else?

Title: Re: Speedbrake armed position
Post by jasonboche on May 31^st, 2020 at 8:06pm

Angel of Attack wrote on May 27^th, 2020 at 8:20am:

It will go to full up when you arm it on the ground, is that the case when you testing?

Correct. Can't be armed on the ground. It's full up or full down. I assume this is how the real 767 works.