Post by Steved on May 11th, 2020 at 1:59pm
PC Aviator wrote on May 10th, 2020 at 2:44pm:
| Has anyone created or found a full fuselage template for painting? For whatever reason CS refuses to provide a full fuselage leaving it to the customers to create their own. The 767 is a nice product but this lack of a full fuse template is one of the shortcomings. Frustrating when you need to line up lines/curves for a repaint or logos that span more than one section of the partials which are in the official paint kit. |
Just create a file 4096 high and 12288 long, copy merged fuse sections 1,2,3 with snap to document bounds and snap to guides enabled onto your new template.
Create vertical guides at 4096 and 8192.
The copied sections should easily snap into place @ 0,0....0,4096....0,8192 when you drag them near the boundaries and/or guides.
Viola', instant full fuse template (only basic though....you can easily use it just as a guide or spend time moving the layers from the fuse 1,2,3 masters over....I just use it as a guide then move the curves and such I need to align across the fuse sections back to their masters...too lazy to spend time building a full master...just a few copy merged's back and forth and I get perfect alignment across the fuse sections.)
Easier to do than explain, but that applies to just about every painting task, LoL
