CAPTAIN SIM FORUM
C-130 X-perience >> C-130 X-perience - General >> ACE start issue
https://www.captainsim.org/forum/csf.pl?num=1582848554

Message started by udidwht on Feb 28th, 2020 at 12:09am

Title: ACE start issue
Post by udidwht on Feb 28th, 2020 at 12:09am
Getting an error upon start of the C-130 ACE

At start...

Small windows with (red X)...Click ok...then....

Small window (upper left says) Aircraft Configuration Editor then below Path for...\SimObjects\Airplanes\CS_130\aircraft.cfg was not found.

Then...

New small window...Aircraft Configuration Editor
Access Violation at address 00416BF2 in module 'ACE_130.exe Read of address 00000000.

Click ok then the ACE opens up.

Clicking on 'Existing' in 'Fleet' tab I'm presented with...
Error: Cannot assign a nil to a TComboxStrings

Click on 'Preflight' tab...
Error: Access violation at address 00416BF2 in module 'ACE_130.exe Read of address 00000000.

Running P3Dv3.4.22.19868 (clean install) under Windows 10 Pro 1909 18363.657

I've tried starting the ACE using compatibility Win 7 mode but no luck there. Same results. 

Title: Re: ACE start issue
Post by sidestickrider on Dec 19th, 2020 at 5:44am
it might work..

1. copy and rename your p3d.exe to fsx.exe
2. run F1 Registry tools, and set FSX path to your newly renamed fsx.exe

ACE were designed to look for fsx.exe location from the registry.

Regards

CAPTAIN SIM FORUM » Powered by YaBB 2.6.0!
YaBB Forum Software © 2000-2021. All Rights Reserved.