CAPTAIN SIM FORUM | |
1011 Captain II >> 1011 Captain II - GeneralĀ >> How to start at a C&D state?
https://www.captainsim.org/forum/csf.pl?num=1566018528 Message started by farman on Aug 17th, 2019 at 5:08am |
Title: Re: L-1011 C&D start not working Post by mark767 on Aug 30th, 2019 at 12:52pm OK I think I figured this out. If you are using the C&D scenario, once you start the ground power (battery on) you need to push the DC BUS ISOLATION switch on the electrical panel and then the power is applied to the aircraft. |
CAPTAIN SIM FORUM » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |