CAPTAIN SIM FORUM | |
1011 Captain II >> 1011 Captain II - General >> How to start at a C&D state?
https://www.captainsim.org/forum/csf.pl?num=1566018528 Message started by farman on Aug 17th, 2019 at 5:08am |
Title: How to start at a C&D state? Post by farman on Aug 17th, 2019 at 5:08am
Hi,
just trying to start at a C&D (last version + P3D v4.5) state, but to no avail. I followed the instructions step by step plus a tutorial video. Am I missing something? After the EP function (or from the eng panel), no lights on he pumps etc are working). Thanks for any help, Fulvio |
Title: Re: L-1011 C&D start not working Post by Fielder on Aug 21st, 2019 at 1:08am this video might be different from the one you saw. about 18:30 into it... https://www.youtube.com/watch?v=K_1SjLmJJwQ |
Title: Re: L-1011 C&D start not working Post by mark767 on Aug 29th, 2019 at 6:38pm I have the same problem. I cannot get some lights to work from the C&D state. Also when switching to APU power (turn off EP) the plane goes dark. Cannot start the engines. Anyone know what is going on? |
Title: Re: L-1011 C&D start not working Post by mark767 on Aug 30th, 2019 at 12:52pm OK I think I figured this out. If you are using the C&D scenario, once you start the ground power (battery on) you need to push the DC BUS ISOLATION switch on the electrical panel and then the power is applied to the aircraft. |
CAPTAIN SIM FORUM » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |