CAPTAIN SIM FORUM - Print Page

CAPTAIN SIM FORUM
757 Captain III >> 757 Captain III - General >> "on APU" panel state issues https://www.captainsim.org/forum/csf.pl?num=1545896370 Message started by Rupert on Dec 27^th, 2018 at 7:39am

Title: "on APU" panel state issues
Post by Rupert on Dec 27^th, 2018 at 7:39am

Hello,

in P3DV4.3 after a change of panel state from ready for take off to "on APU" the clickspots in the VC center pedestal are not clickable, in the 2D panel they work.

Any suggestions?

thx

Title: Re: Version 1.3 is available
Post by FraPre on Dec 27^th, 2018 at 10:52am

Hi,

can it be that with version 1.3 (FSX) at least the starting state "ON APU" is no longer correctly built up? For me, many switches are on, which should be off, but the switch for the APU, which is running, is OFF. I then completely uninstalled the whole time completely and reinstalled version 1.3, but no succes.

Title: Re: Version 1.3 is available
Post by Captain Sim on Dec 27^th, 2018 at 3:23pm

FraPre wrote on Dec 27^th, 2018 at 10:52am:

No need to reinstall. You can just re-save the flight with any corrections.
Moreover custom panel state setup is available via FMC.

Title: Re: Version 1.3 is available
Post by FraPre on Dec 27^th, 2018 at 3:29pm

I had done that first too, but unfortunately I found the wrong startup status "ON APU". Then I completely reinstalled everything. The wrong condition of many switches in this starting situation remained unfortunately. In version 1.2 there were no problems.

Title: Re: "on APU" panel state issues
Post by Captain Sim on Dec 27^th, 2018 at 3:33pm

Thanks, we'll check the "on APU" panel state.