CAPTAIN SIM FORUM - Print Page

CAPTAIN SIM FORUM
767 Captain (FSX) >> 767 Captain (FSX) >> Apu shutting off after doing normal start up...and https://www.captainsim.org/forum/csf.pl?num=1532633540 Message started by jupdaddy on Jul 26^th, 2018 at 7:32pm

Title: Apu shutting off after doing normal start up...and
Post by jupdaddy on Jul 26^th, 2018 at 7:32pm

Apu run blinks on and off....then does not work. Tried what everyone said in previous treads and not working.

Also once plane is airborne and AP is on....plane does rocking left and right motion and trims up....u know a stall was coming.

I need solutions.....that work

Title: Re: Apu shutting off after doing normal start up...and
Post by Markoz on Jul 27^th, 2018 at 1:56am

When you installed the CS 767-300 Base Pack, did you install it using "Run as administrator", and your Anti Virus software OFF/disabled?

I just did a flight in the CS 767-300 in *FSX-SE, on Windows 10 Pro 64bit, and the APU, and the AP, worked just like they should, and it was installed as I described above.

* I not able to activate FSX Acceleration on my PC, so I'm stuck using FSX-SE until I fix the problem of activation.

Title: Re: Apu shutting off after doing normal start up...and
Post by jupdaddy on Jul 27^th, 2018 at 11:36am

I will give that a shot...again. Now to solve my plane rocking when I use AP :(

Title: Re: Apu shutting off after doing normal start up...and
Post by jupdaddy on Jul 27^th, 2018 at 3:35pm

Nope.....didn't work >:( >:( >:(
APU powers up to about 350 and then dies out

Title: Re: Apu shutting off after doing normal start up...and
Post by Markoz on Jul 28^th, 2018 at 2:52am

I'm sorry to hear you are having these problems. I have never had these problems. The biggest problem I ever had, was with the TD not appearing on the route, because of the STAR/TRANS not apearing/working correctly when creating a route, which I have not encountered in a long time.

Title: Re: Apu shutting off after doing normal start up...and
Post by David Paul on Jul 29^th, 2018 at 12:58pm

I have to re-load the 767 to get it to work properly.