FlavioSSA wrote on Jul 21^st, 2015 at 11:56pm:

mark767 wrote on Jul 19th, 2015 at 10:20pm: I cannot get the flaps gauge to work.  The flap lever moves, the flaps themselves move but the gauge stays in the "up" position.  Anyone else have this issue. For the guys with the "flap issue", just goes in the engineer panel and turn on electrical feed to engine1. The flap gauge will work after that.

Thank you, Flavio. Yes, Essential Power Selector should be switched to the "powered" source and Essential Power Failure Warning Light should be extinguished.