Hi, Robinking,

A few suggestions:

1) Make sure your joystick is actually moving the control surfaces -- look from outside or check the flight controls page.  Sometimes the aircraft loads with switches that affect hydraulics to the controls set to "off."  These switches are located high up on the overhead panel.  They must be switched on.  Check that all the controls move: elevator, ailerons, rudder.

2) Check your elevator trim.  If it's below around 6 or so (depending on weight and weigh distribution) you may not have enough elevator effect, even with full back pressure on the joystick, to rotate the aircraft.  

3) Looking at your screen shot, it looks like you may not have any flaps set.  You need at least flaps 5.

Hope this helps!

Mike