CAPTAIN SIM FORUM | |
777 Captain (32-bit) >> 777 Captain (32bit) - General >> Engine Hydraulics
https://www.captainsim.org/forum/csf.pl?num=1362880579 Message started by CameronL on Mar 10th, 2013 at 1:56am |
Title: Re: Engine Hydraulics Post by tf51d on Mar 10th, 2013 at 5:40am CameronL wrote on Mar 10th, 2013 at 1:56am:
The 777 is unique as it not only models the overhead, but also maintenance switches that ground personnel would use. If you look on the upper overhead on the right side, you'll see a group of guarded switches, which are defaulted on as well as cargo temp knobs. These are maintenance switches, that need to be turned of. Set the cargo temps as desired. Then over on the left side (Pilot side) are a set of nine guarded switches, the lower six, which are for the hydraulics are defaulted off. These all need to be turned on. The upper 3 are for standby window heat, and standby power. I leave these in their default positions. Now the hard part is access. It's almost impossible to do it from the pilot seat. If you have EZDOK or OPUS you should be able to create individual views which will make it easier. If not you'll have to use the view controls within FSX to do this. (CTRL/Enter or Backspace for longitude, CTRL/Shift-Enter or Backspace for lateral. It's nice that the switches are modeled, and obviously function, but I wish they defaulted to flight mode. As for D-TO you should find this on the thrust limit page |
CAPTAIN SIM FORUM » Powered by YaBB 2.6.0! YaBB Forum Software © 2000-2024. All Rights Reserved. |