Try the following way using the 2D OH Panel 1 (Upper) and 2D Throttle Quadrant Panel only.





[/td] [/tr]

Battery	-	TO ISOLATED DC BUS
SimIcon Panel (SHIFT+2)	-	Press E to give you External Power
EXT AC PWR	-	ON
Co-Pilots AC Instruments	-	ESSENTIAL AC BUS
AC INST & FVM CONT	-	ESSENTIAL AC BUS
Engine Bleed Air Valves #1, #2, #3 & #4	-	OPEN
Engine #3 Condition Lever	-	AIR START (returns to RUN position when released)
Engine Ground Start Button #3	-	*PRESS and release.
After engine #3 starts
Generator Selector Switch #3	-	OPEN/ON
Engine #4 Condition Lever	-	AIR START (returns to RUN position when released)
Engine Ground Start Button #4	-	*PRESS and release
After engine #4 starts
Generator Selector Switch #4	-	OPEN/ON
Engine #1 Condition Lever	-	AIR START (returns to RUN position when released)
Engine Ground Start Button #1	-	*PRESS and release
After engine #1 starts
Generator Selector Switch #1	-	OPEN/ON
Engine #2 Condition Lever	-	AIR START (returns to RUN position when released)
Engine Ground Start Button #2	-	*PRESS and release
After engine #2 starts
Generator Selector Switch #2	-	OPEN/ON

See if that gets them started.

Mark