Mark,

I have been using V3.51 for a long time now and it gave me a wierd error to do with Makemdl and would not compile at all. My conclusion was that this model is very small in size, as if I added just one other large size part (a big tube) then it compiled OK.

Then the other day it came in a flash! I thought about using the old version that I still have loaded, and use from time to time. It worked no problem. I do know that in V3.xx Abacus did go over to using the Makemdl & Xtomdl compilers (To make models compatible for FSX) and before they used their own one, so I can only assume this was the problem.

Also off subject again. Do you know how to calibrate the 2D HUD? The red ring that appears is above the HUD generated by CS, It does not tell you what parameter to adjust to bring them level. I have had a play but no joy so far.

Take care

Pete