Post by Markoz on Feb 12th, 2011 at 1:23am
Hi Ricardo.
The main difference between my settings and yours, from what I see in your image, is: In the bottom right of the image (see attached image), I see that you have the AC Meters Selector switch is set to BUS TIE. I set mine set to either GEN1, GEN2 or GEN3 (usually the same GEN# that my Essential Power Selector switch is set to). Try changing that to see how it works out.
If none of this works. Try pressing CTRL+E (MSFS default engine start) while in flight, this will usually bring back your avionics. That is what I did originally, until I sorted this problem out.
Hope this helps.
Mark
ACMetersSelector.jpg (Attachment deleted)
The main difference between my settings and yours, from what I see in your image, is: In the bottom right of the image (see attached image), I see that you have the AC Meters Selector switch is set to BUS TIE. I set mine set to either GEN1, GEN2 or GEN3 (usually the same GEN# that my Essential Power Selector switch is set to). Try changing that to see how it works out.
If none of this works. Try pressing CTRL+E (MSFS default engine start) while in flight, this will usually bring back your avionics. That is what I did originally, until I sorted this problem out.
Hope this helps.
Mark
ACMetersSelector.jpg (Attachment deleted)