Breaking out the old lady, and was going through this thread for CIVA installation.   Not sure it could be any more confusing.   But in the hope that it can become less confusing can we get a complete panel setup how it should be with everything there instead of piece mill lines.    Holy wow does that make it really confusing.   I've tried going backwards but that wasn't much help either.   

Just for clarification sake:  There is two panel.cfg in my panel folder so I should be updating the CIVA_Panel.cfg.

Then It will replace the panel.cfg as the main cfg in the PANEL folder?  For the CS_707-300, CS_707-300C, CS_E3       RIGHT?

Thanks
Don