Post by Markoz on Mar 30th, 2010 at 10:27am
I ran that program on the 727-100. It's default distance is about 32 meters. First I changed it 20 meters, and it looked OK (and close).
Then I changed it to 10 meters, which is too close, all was NOT OK. When I returned to the VC looking straight ahead, it was like the view from the 2D cockpit. If I swiveled around by more than 90 degrees, the VC could be seen, but only in the direction I was looking.
At a setting of about 15-16 meters, everything appeared OK, including everything in the VC.
Before (default distance)
After (radius down to about 16 meters)
What I don't understand about this, is how changing the external view radius can have an affect on the VC :-? The VC in 727-100 is a separate model to the exterior.
Mark
Then I changed it to 10 meters, which is too close, all was NOT OK. When I returned to the VC looking straight ahead, it was like the view from the 2D cockpit. If I swiveled around by more than 90 degrees, the VC could be seen, but only in the direction I was looking.
At a setting of about 15-16 meters, everything appeared OK, including everything in the VC.
Before (default distance)
After (radius down to about 16 meters)
What I don't understand about this, is how changing the external view radius can have an affect on the VC :-? The VC in 727-100 is a separate model to the exterior.
Mark