CAPTAIN SIM FORUM - Print Page

CAPTAIN SIM FORUM
MSFS2020 >> 717 Captain >> Lost of electrical power https://www.captainsim.org/forum/csf.pl?num=1701361653 Message started by EDawg109 on Nov 30^th, 2023 at 4:27pm

Title: Lost of electrical power
Post by EDawg109 on Nov 30^th, 2023 at 4:27pm

The jet starts up fine with no issues but while taxing to the runway all the power shut off. This is on the latest ACE 1.00.5 update. Does anyone else have this problem?

Title: Re: Lost of electrical power
Post by Rudolf on Nov 30^th, 2023 at 5:10pm

Did you turn on the engine generators? Since update 1.005, these are no longer on by default.
Somit wurde die Batterie leergesaugt.... :(

Title: Re: Lost of electrical power
Post by EDawg109 on Nov 30^th, 2023 at 6:17pm

The apu isn't generating power either. the minute I disconnect the ground power everything shuts off.

Title: Re: Lost of electrical power
Post by EDawg109 on Nov 30^th, 2023 at 6:51pm

The apu started on the first load up now it doesn't want to run. see it try to start then shuts down.

Title: Re: Lost of electrical power
Post by Rudolf on Dec 1^st, 2023 at 12:27am

EDawg109 wrote on Nov 30^th, 2023 at 6:51pm:

The apu started on the first load up now it doesn't want to run. see it try to start then shuts down.

...look here...
https://www.youtube.com/watch?v=2H6z-c6qe88

and do not click any other buttons or switches during this procedure

Title: Re: Lost of electrical power
Post by EY on Dec 2^nd, 2023 at 6:32pm

if you use APU make sure that its generator is on, otherwise when APU is running the airplane will be powered by the battery

electro-717.png ( 403 KB | 176 Downloads )

Title: Re: Lost of electrical power
Post by Rudolf on Dec 3^rd, 2023 at 6:30am

thanks for the explanation picture.....thats great... :D

Title: Re: Lost of electrical power
Post by EDawg109 on Dec 7^th, 2023 at 3:43pm

Rudolf wrote on Dec 1^st, 2023 at 12:27am:

EDawg109 wrote on Nov 30^th, 2023 at 6:51pm:

The apu started on the first load up now it doesn't want to run. see it try to start then shuts down.

...look here...

and do not click any other buttons or switches during this procedure

Thanks for the info I'll give that a try.