Hey Everyone! I am posting my to this topic at the request of the support team. See below:

"I programmed the MCP Autopilot buttons to work with saitek multi panel through the SPAD.next application using the newly released SDK. The button on the autopilot do not funtion properly when programed this way. I tried to use LUA scripts as well and the same issue. The buttons work as intended when using the mouse. The buttons on the 757 MCP get stuck in the pressed position when toggled by the saitek panel. I have set them up per the instructions of the manual provided with the sdk. I tried a set parameter to 1, toggle parameter to 1 and 0 as well. None of these activate the button like a mouse click would.
It happens anytime while using a saitek multi panel to control Autopilot functions.
When using a mouse to select V/S button it presses in momentarily and then release with the button being highlighted. WHen the saitek panel VS button is pushed the V/S button in sim sticks in the pressed in position. If I toggle it again via the Siatek panel it releases, but does not activate. I have read the momentary switch/button section of the manual as well. Do I need to make a video or set of pictures for you?"

Regards

Mike 'Walker605' Allen