Hi Guys, I have just purchased the 727-100 Base Pack for FSX. I have installed the aircraft successfully however the flight controls are unresponsive. I am not sure how to fix this as the flaps and slats are working fine, therefore i dont think it is a simulated hydraulic issue. then engines work fine but having no ailerons, elevator or rudder control is making flying a little tricky for me. If anyone can help with this i would hugely appreciate it.

Cheers.

Probably a registration error. Try reinstalling and making sure you've got the right registration code. I say this because in the demo version of CS products, all control surfaces are locked.

727 Captain’ FLIGHT MANUAL Part II – Aircraft and Systems, page 91 (csx727_manual2.pdf) W10. HYDRAULIC PANEL
Make sure switches 1,3. System A Pump Switches and switches 9,11. System В Pump Switches are ON, and the the lights above them are OUT.

727 Captain’ FLIGHT MANUAL Part II – Aircraft and Systems, page 71 (csx727_manual2.pdf) U03. ELECTRICAL POWER PANEL
Make sure that the 5,14,22. Generator Breaker Switch are closed, if they flick back to the center position, that's fine. I usually return them to the center position if they don't do it themselves. The lights should go out.

There could be something else that might causing your problem, but I'm flying the CS737-100 at the moment. I'll check it out when I finish my current flight.
Scratch that. I was thinking of something on the CS707. :-[

Mark

Just wanted to say thanks for helping me out on this guys. It did turn out to be an installation problem as you thought boeing247. Very much appreciate it and loving the 727!!

Cheers.