Tks for your informatio,

I'm using this configuration

[LIGHTS]        
light.0 = 1,   0.70,   0.00, -3.90, fx_shockwave_beaconh , //fx_beaconh
light.1 = 1,  40.00,   0.30, 10.57, fx_shockwave_beaconh , //fx_beaconh
light.2 = 4,  67.00,   2.00,  5.19, fx_shockwave_vclight_l , //fx_vclightwhi
light.3 = 4,  67.00,   -2.00,  5.19, fx_shockwave_vclight_l , //fx_vclightwhi
light.4 = 5,  15.35,   7.35,  0.10, fx_Shockwave_landing_light ,      //cs757_land
light.5 = 5,  15.35,  -7.35,  0.10, fx_Shockwave_landing_light ,      //cs757_land
light.6 = 7, -17.00, -47.00,  2.50, fx_Shockwave_landing_light ,      //cs757_sf
light.7 = 7, -17.00,  47.00,  2.50, fx_Shockwave_landing_light ,      //cs757_sf
light.8 = 8, 13.40, -17.47, 3.40, cs757_edge
light.9 = 8, 13.40,  17.47, 3.40, cs757_edge

It's only a tentative to do it. I think it is possible to do it better. There are a lot of effects installed and Shockwave Manufacture don't have yet a configuration predefined.

The effect is realy nice and soberb, but I can't put the shockwave lights in the nose gear lights. Don't know how to do it! Does someone have any idea? Perhaps those lights are linked to the 3D model. Don't know!

PS: don't forget to put the below line in the VC1 section:
gauge28=shockwave_lights!SW Lights_gear,  1,1,1,1 //shockwave light