Ok here goes.

1. Turn the battery on and open the bus tie switch
2. Open the GTC Door and turn the GTC control to START and let go.
3. Once the GTC has run up and the ON SPEED light is illuminated open the GTC bleed air valve.
4. Once the duct pressure has stablised you can start the ATM generator. Reset the ATM generator and put it on line.
5. Open the bleed air switch to the engine you wish to start.
6. Move the corrisponding condition level to AIR START and release. (It returns to the run position)
7. Press the relevant engine start button and wait until the RPM and TBT increase and the light above the start button illuminates. Release the START button.

You should now have a running engine. I could make it a lot more complicated but the guys at FS Station have done a great tutorial. You can visit the site using this link.

http://www.fsstation.com/tutorials/legendaryc130.html

Hope this helps.

Dax